Differences

This shows you the differences between two versions of the page.

--- gp_simulator:usrp_calibration_procedure [2019/02/26 19:31]
yasko
+++ gp_simulator:usrp_calibration_procedure [2019/02/27 15:06] (current)
admin
@@ Line 1: / Line 1: @@
 =====USRP Calibration Procedure=====
-To calibrate the USRP, follow the steps provided below. In the "USRP" tab:\\
+To calibrate the USRP, follow the steps provided below.
-  * Check the "Conducted connection" box; \\
-  * Define the corresponding values in the "USRP Cal Facrotor, db" and "Attenuator, db" fields, set "Cable Length" to 0, and then select the required "Spoofing Mode."\\
+In the "USRP" tab:
+  * Check the "Conducted connection" box;
+  * Define the corresponding values in the "**USRP Cal Facrotor, dB**" and "**Attenuator, dB**" fields, set "**Cable Length, m**" to **0**, and then select the required "Spoofing Mode;"
 {{:gp_simulator:gp-simulator_usrp_calibration.png?600|}}
@@ Line 9: / Line 11: @@
 \\
-  * Connect RF outlet of the USRP to the spectrum analyzer or RF power meter. When using the spectrum analyzer, we recommend setting its CF to 1575.42 MHz, bandwith to 10 MHz, and switch on power measurement mode;
+  * Connect RF port of the USRP to the spectrum analyzer or RF power meter. When using the spectrum analyzer, we recommend set **CF** to **1575.42 MHz**, **bandwidth** to **10 MHz**, and switching on the power measurement mode;
-  * Set "DUT input power, dBm" to "-20 dBm;"
+  * Set "**DUT input power, dBm**" to "**-20 dBm**" respectively;
-  * Click on the  "Scenario Start" button.
+  * Click on the "Start Scenario" button to finish;
 {{:gp_simulator:gp-simulator_usrp_start_calibration.png?600|}}
@@ Line 23: / Line 25: @@
 <WRAP left round info 60%>
-The measured power in the bandwidth should be within "-45 dbm" range.
+The measured power in the bandwidth should be within the "-45 dBm" range.
 </WRAP>
 \\